意思翻译
烟囱锥度
拔模角，[机]模锻斜度；拔模角度，[机]拔模斜度
相关相似draftable───adj.可征召入伍的
rake angle───倾角；刀面角；投弹角
seat angle───支座角钢；阀座倾斜角
secant angle───割线角
straight angle───n.[数]平角
craft knife───n.美工刀
detangle───v.理顺（头发）
双语场合用语upper die of the new type of finish forging die so that pattern draft Angle of half axle of forging is small oversize for machining is little.───新型精压模的上模设有顶件装置锻件半轴的拔模斜度小锻件半轴的金属敷料少。
Design: adopt small draft Angle to reduce soldering, avoid sharp corner to reduce crack, optimize runner system to reduce erosion.───设计：选用小的脱模角度减少粘焊，避免尖角应力造成开裂，优化流道设计减少冲蚀…更多。
red highlighted area has a problem of a small draft angle, we suggest enlarging the draft to avoid causing drag marks on the part.───红色显示的部位拔模角度太小，我们建议加大拔模角来防止产品拉伤。
The forging die has no draft angle and the material utilization rate is increased about 12. 5%.───该模具结构使锻件的外形略去拔模斜度，材料利用率提高约12.
since the draft angle was changed, we need to lower the parting line for the mold.───由于角度改变，模具分型处要降面。
We suggest to enlarge the draft angle to help release the tool.───建议加大拔模角，以便脱模顺利。
Enter a sweep distance of 0. 9 mm and a draft angle of 4 degrees.───输入打扫距离0.9毫米和4度拔模斜度。
MOLD CENTER LINE TEXTURED SURFACE DRAFT ANGLE───模具中心線咬花面拔模角
The draft angle is changed from 1 degree to 3 degree. A───出模角度由1度改为3度。
英语场合用语There is a shedder on the upper die of the new type of finish forging die, so that pattern draft angle of half axle of forging is small, oversize for machining is little.
延伸推荐- drafting desk
- drafted by det
- drafting tools
- drafted in
- draft angle
- drafts hamlin pa
- drafted by thomas jefferson
- drafted cv
- draft letter
- drafted ahead of jordan
